Live performance with both instruments
Break Surgeon (A) on one mixer channel, Abyss Engine (B) on another. The mixer's model is not confirmed: nothing here assumes it has MIDI, effects, sends or a particular routing. Each FM-1's output is stereo (headphone jack); A's signal is mono-compatible by design (the drum bus is mono), B's sub and bass are centred.
Before the set
- Link (optional): see docs/architecture/link-protocol.md for the routes; set the same LINK CH on both. On A: SYSTEM K4 SYNC OUT = ON, CLOCK = INT. On B: FOLLOW = LINK. Without a link: same BPM on both, PLAY together, SOLO DUCK on B.
- Gain: MASTER on both at about 3/4. A's ceiling is −0.5 dBFS with typical peaks around −2.5 dBFS (renders: peak 0.75 at MASTER-equivalent 0.9); B peaks similar with more RMS (bass). Set the mixer channels so B's sub sits under A's kick, not on top: start with B's channel ~3 dB below A's and adjust by ear on the actual PA.
- Low end: B's sub lives at 36–72 Hz, mono. If the PA has a crossover, check the sub on it before the set (docs/development/testing.md, listening checklist).
- Save both (stopped).
A 20-minute improvisation (one route through it)
| Time | Break Surgeon | Abyss Engine | Mixer |
|---|---|---|---|
| 0:00 | stopped | scene INTRO (pad only), PAD HOLD, MORPH low, SPACE high; play pad chords on the keys (SELECT → PAD; SEL + REC holds the pad) | B up, A down |
| 1:30 | PLAY with scene INTRO (thinned break, no synth kick/snare) | keep the pad; slowly raise DARKNESS / EVOLVE | bring A in |
| 3:00 | scene BUILD (rolling, more hats), K4 FILL AMT up | scene BUILD: a sparse bass enters | |
| 4:30 | FILL 2 bars (SEL + ENV) into... | FILL (ENV): bass rolls into the drop | |
| 5:00 | scene DROP (kick + snare + full break) | scene DROP (bass line, sub, pad released) | both full |
| 7:00 | BREAK knob toward CHOPPED; hold CHOP / REVERSE for single bars | MORPH through TALK → GROWL; MOTION up | |
| 9:00 | MUTATE (LFO), keep it or SEL+LFO to undo | MUTATE (LFO) on the bass; SNAP (PRESET) back to a node | |
| 10:30 | scene VOID (break fragments, drums muted) | scene VOID (pad, no bass), SPACE up | A down a little |
| 12:00 | FREEZE (white 7) held over the last beat, release on the one | stab chords on the keys (SELECT → STAB) | |
| 12:30 | scene IMPACT (half-time, INDUSTRIAL kit) | scene IMPACT (stabs, aggressive bass) | |
| 14:00 | FILL 4 bars (black 10), then scene MUTATION | scene MUTATION (BITE high) | |
| 16:00 | KIT knob toward METAL TECHSTEP; PRESSURE up | EXPLORE (ALGO) to REESE DARK | |
| 18:00 | REC (RETURN) on a bar: the clean groove | REC (RETURN): SNAP; MORPH to DUB, BITE down | |
| 19:00 | mute KICK and SNARE (white 10, 11), leave the break | PAD HOLD on (SEL + REC), bass muted (SEL + black 1) | |
| 20:00 | STOP on a downbeat | the pad's tail rings out (SEL + REC: PAD HOLD off) | fade |
With the link, a scene pressed on A goes to B as well (same number, same bar). Scenes stored on each device should correspond (scene 3 = DROP on both).
The same hands on both
Both firmwares share their buttons, so a gesture on one does the same on the other:
Since 0.5 both are step sequencers first: the white keys are always the 16 steps of the selected track, the black keys pick the track, and the live tools sit on held buttons (let go and you are back).
| Break Surgeon | Abyss Engine | |
|---|---|---|
| white / black keys | the steps / track BREAK…IMPACT | the steps / track BASS STAB PAD |
| PLAY / SEL + PLAY | start, stop / panic | start, stop / panic |
| hold FX + white | performance FX while held (ROLL, CHOP, TAPE STOP …) | performance FX while held (OCT UP, FILTER DIVE, WOBBLE …) |
| hold ARP + white | queue scene 1–8, pattern P1–P4; black: mutes | the same |
| tap ENV / hold ENV + white | a fill in the phrase's last bar / ROLL, SNARE BUILD, DROP OUT, CHOP now | the same / ROLLS, OCTAVES, DROP OUT, SLIDE DOWN |
| tap LFO / hold LFO + white | mutate the track / variation A–D, white 9–14 the FORM | mutate the bass / answer A–D, the FORM |
| REC / hold REC + white | record the keys into the track / erase a step | the same (the keys are notes) |
| hold SAVE + white | store scene 1–8 | store scene 1–8 |
| SEL + LFO / SEL + ENV | undo / redo (8 levels) | undo / redo |
| SEL + REC | RETURN to the scene's state | RETURN |
Call and response across the rig: FORM A B A C on Abyss puts its answers on bars 2 and 4 of every 4, the global grid Break Surgeon's phrases, fills and conditions use too. With FILL ANSWERS on (Abyss SONG page), a fill on Break Surgeon makes Abyss play its answer C under it; with LOCK TO KICK the bass plays on Break Surgeon's kicks. Trig conditions (PHRASE END, 4:4, FILL …) count bars on the same grid on both, so a step set to PHRASE END plays in the same bar on both machines.
Each screen shows, at the bottom, what the keys and encoders do right now; a held layer shows its name and its keys.
Transitions that work
- On the bar, every time: scenes and pattern changes are quantized (SCENE K1); press anywhere in the bar before.
- Fill into a scene: FILL first, the scene on the same bar: the fill ends with an IMPACT hit on the downbeat.
- Safe exit: SEL + REC (RETURN) on either brings the scene's state back at the next bar; SEL + LFO undoes the last change, SEL + ENV redoes it.
- Panic: SEL + PLAY on either device stops and silences it.
Gain staging inside the instruments
- A: PRESSURE adds density, not level (it trims as it pushes). Watch the FX page's peak meter: red is the ceiling.
- B: BITE and DIRT are trimmed; WEIGHT changes only the sub. The guard catches show on the FX page: occasional is fine, constant means MASTER or PRESSURE is too high.
Hardware checks still pending
Everything above is designed and runs in the simulators. Before relying on it live: the FM-1 tests in docs/development/testing.md (§ hardware), especially CPU load with everything playing, saving, and the link.